CPU "FAN2" connector without voltage

o-d-f · Post by **o-d-f** » Sat Jul 14, 2007 2:57 am

Hi BP6 community,

i have a Problem with my BP6 Board. The CPU FAN1 is rotating and the CPU FAN2 doesn't work. So i measured the voltage on both connectors. On FAN1 are 11,9V and on FAN2 0V.

Is there anywhere a fuse wich i can change or solder a bridge? At the moment i am using the two coolers paralel over the connector "FAN1", but this solution is to easy

Is there any chance to repair it? THX for your Tips.

cu,

o-d-f

tenchimuyo93 · Post by **tenchimuyo93** » Sun Jul 15, 2007 4:40 pm

wish i could help, mine has 0v on both cpu fan headers. so i just use 12v right out of the power supply. matter of fact every fan on my bp6 is at 100% power thru the molex connectors.

KliK · Post by **KliK** » Fri Jul 20, 2007 6:38 am

or use the FAN3, which is under the HP366 chip!

Post by **Derek** » Mon Jul 23, 2007 6:11 am

Someone did repair their fan headers. The info should be hiding on the message board somewhere.

I'm on the road at the moment so you'll have to search

o-d-f · Post by **o-d-f** » Thu Jul 26, 2007 10:53 am

THX Derek, i have found the article:

http://www.bp6.com/board/viewtopic.php?t=2426

Now i need only this smal transistors

tenchimuyo93 · Post by **tenchimuyo93** » Thu Jul 26, 2007 6:52 pm

wow those are tiny, but ill give abit credit, they look atfer their product and customers.