Johnny 5 at warp 7!

jaybird · Post by **jaybird** » Thu Apr 13, 2006 7:52 am

Just completed my latest up grade to my V0.41 board, replacing the old GlobalWIN FEP-32's with modified Spire Whisper V coolers.

I found the coolers at Newegg for $4.99 + SH & HDLG (these have quiet low speed 27 cfm fans), found 5 Delta 80mm 47 cfm fans for $10 + SH & HDLG on eBay and swapped everything out last night.

I am writing this using my lapped 366's @ 594 mhz

!

CPU temps have dropped more than 5 deg. F (as seen by MBM 5.0), case temps have gone up over 10 deg. F indicating to me that the modified Spire's are doing their job, now I just need to install the 3 othere Delta's as case fans and get the heat out of the case!

Have been able to go into Windowz @ 605 and run CPU BURN-IN for 15min before lock-up.

Humm, maybe some Pelt's under the Spires

? (just saw some pelts on eBay that come with a automatic temp controller to help avoid condensation)

Have taken pic's of before and after, did require r&r of mobo but the installation was very easy and the Spire clips were much easier to use than the GlobalWIN clips.

OBTW, just located another 1100E!

We ain't dead yet!

Regards,

jaybird

davd_bob · Post by **davd_bob** » Wed Apr 19, 2006 12:26 am

u da man!!!

BTW, what measures are you taking to protect the BX? You know that when running over 100fsb on dual CPUs a BX440 can cook red meat as well as any charcoal pit.

jaybird · Post by **jaybird** » Wed Apr 19, 2006 10:07 am

Yeah man!

To answer your question(s):

I have intalled a "mini-peltier" on the BX chip set w/386 fan.

Whisper V with Delta 80mm fans (big mistake noise wise!)

I now have a "747" on my desk-top!

OBTW, please see my pics, this website, "your picture gallery, jaybird".