BP6.Com

Don't hard drives have problems if you get too far from a 33 mhz bus?

Is there a way to set FSB independent of CPU?

Well I tried changing the setting to show Vcore but it didn't seem to work. After learning its showing the VTT though I decided I preferred that.

I've used all different components with no success. Since the sound was stuttering I replaced the sound card first. I was using the Creative and found all kinds of bad things out about them inculding the SMP problem. I'm using a Santa Cruz now. Only oher components in it right now are a GeForce 3 an...

I fired up my old BP6 while I'm waiting for an Athlon Mobile to replace my dead cpu and noticed I'm having the same problem I've always had, computer locks up with the sound stuttering when playing games. I've got 2 400's that I got from Allstarshop running at 550. My vcore is set at 2.2 but runs be...

I have both Vcores set to 2.2. Sandra says they are both around 2.16 while motherboard montiro says cpu 0 is 2.16 but cpu 1 is 1.52. Cpu 0 has always run about 2 degress celsius hotter, right now they are at 43 and 41. Who do you think is right?

I did find a post saying it was not uncommon for Live cards to have problems with SMP. Can anybody reccomend a good card for SMP. I do have an old SoundBlaster AWE ISA card I could use.

I just did a fresh install of 98/2000. Win98 is working fine but in 2000, I get stuttering sound and random crashes and restarts. I have a network card in slot 2, sound card (SoundBlaster Live) in slot 3, modem in slot 5. I updated to RU and HPT 1.25 BIOS but have not installed the HPT drivers, I am...

Yes the caches were disabled. Setting the cpu speed has been very bizarre. I orignally tried the stock settings 433/66 but when booting up it would report it as 400 and refuse to boot. I had to disable the speed hold and set it to 6.5x 94 mhz. It reports this as 500 but it finally would boot. I'm th...

I flashed to the bp6ru125 bios before installing Win2K and I got the above error. There were a bunch of bad commands at the command line before the flash program ran then the program seemed to write just fine and after I exited it got a bunch more bad commands at the command line. When it booted bac...

The boot screen says its the RU bios and the HPT125 bios. I tried hitting f6 during the win2k installation to install third party drivers but it doesnt seem to acknowledge it and goes on to the hardware detection.

I flashed to the bp6ru125 bios before installing Win2K and I got the above error. There were a bunch of bad commands at the command line before the flash program ran then the program seemed to write just fine and after I exited it got a bunch more bad commands at the command line. When it booted bac...