BP6.Com

Sorry for the late reply, I don't visit this site too often. If you emailed me I could have answered in a few hours. Anyways the cheapest shipping is around $24 to Croatia with the Postal service which is kind of a lot for only $15 in heatsinks. There was $12 option via the Postal Service but the bo...

For sale: A pair of Alpha PAL6035 copper bottom heat sinks (fins are aluminum) with 80mm fans, fan adapters and retention clips. Also have the boxes, Alpha stickers, instruction manual and eight foam rubber feet. Fans are Y.S. Tech FD1281255B-2A (~ 37cfm). This setup does fit a BP6 with the fan adap...

I was searching for this connector. My fans had three wires however they were wired up to standard molex connectors with the sense wire not being used. http://www.frozencpu.com/images/products/large/ele-191.jpg There are a few places on the internet that carry them, however some of the vendors don't...

I went ahead and tried it and got somewhat mixed results. The fans are definitely running slower, and with speedfan when trying to variate the fan speed, the fans seem to be struggling when stepping the speed up or down. I only ran it for around 3 minutes, so I'm just going separate fans again using...

Been a long time since I posted, but I dusted off my BP6 and have it running again. :D I have a question about the fan headers though. I'm thinking of jerry rigging two 80mm fans together on one fan header. The fans are Y.S. Tech FD1281255B-2A which draw 1.92watts each. So combined it would 3.84 wat...

I've updated first post please read.

Yes the 2 processors on the board comfortably overclock to 550Mhz.

***Please read first: I have been testing the board today, and can't seem to get it to pass memtest86 when overclocked. So I'm not going to sell it. Make an offer if you like, or I might part it out later on. The memory is still good, and I've even tried a known good ECC module and I still get erro...